Can you offer us a start to finish turnkey project? Yes, of course. If you wish, we can provide you a total turnkey package. TurnKey is where we can take care of all of the Designs, Utilities, Permits, Drawings, Excavation, Recycle permits, Electrical, Piping, Paving, Masonry, Inspections. It is turnkey.
This way if you have a question, wish to change something, you only have to call one number.
Call us if you have any questions 973 728 5745
Our Warranties are up to 20 Years!
Competitors Only 5 years or 10. Remember that Material Quality counts. If the Warranty is low so is the material quality.
A system designed by us and installed by us will uses about 50% less per square foot to run than other systems.
Call us if you have any questions 973-728=5745
Our Materials are the absolute toughest grade radiant materials you can use. GUARANTEED.
You may say, Prove it! We say No Problem.
We will let you hit our unprotected radiant material with a hammer... 1x time with a hammer! Not enough ok ... what about.. 2x times with the same hammer! Still not convinced? ok .. tell you what, we'll let you hit our radiant material with a hammer 10x!
You read that right - you can hit our unprotected material 10x times, then we'll plug it in and you can watch it work just fine.
Then lets try it with a standard radiant wire cable and see what happens.
Be wary of these over the phone internet sales companies that only sell radiant parts but do not install. They get anyone local to install for you even if they have not installed a system before.
We can provide so many stories of systems that we were called in to fix because those companies could not finish or damaged the system while installing them. We will provide references.
Ask what could happen to the installation if someone hit their radiant wire cable with a hammer.
Our In-ground radiant materials are USA Made. This is not simple flag waving here, its just that we know the other overseas or imported brands. Ours is better by far, it cost a bit more but we provide up to a 20 year warranty.
Can they say that? No...
Call us if you have any questions at 973-728-5745
Compared to standard cable systems our materials are called "Lay Flat Radiant" which provides 100% coverage of the area where the materials are installed. Providing much faster heat up, much more surface area at about 50% less energy.
We are the factory authorized Designer, Distributor, Installer - all in one turnkey package.
We are factory authorized for all the products we install. Whether its the ground fault system, all the radiant materials, sensors, surge protection devices, wiring, piping, generator, control package, we offer
One Stop Convenience
Why have to deal with one designer, a separate excavator, a separate Installer, a separate mason or paver? What about having to stay home all day waiting for the utility inspector or waiting from 9 to 5 for each township inspector?
Call us if you have any questions 973-728-5745
When Quality Matters Call Us. Get it Done right Once
Ok somehow you're still not convinced. We understand - we too are consumers. Lets face it we all hear sales pitches all day long on radio, tv, internet. We understand.
How about this. We will put a $100.00 bill in your hand. Then we will let you in your own car or truck run over our materials while it lays on your own driveway. You can run it over back and forth as many times as you want, then lets plug it in and watch it heat up. If it doesn't work? You keep the money! Hows that?
Remember this, if the radiant materials can hold up to direct abuse by your car or a hammer, imagine how long it can last while protected under your cement, paver bricks or asphalt driveway, walkway or patio. That is why we offer the best warranty in the business - up to 20 Years!
Driveway extremely steep? Worried about the car sliding into the garage or the street?
Walkway and steps too slippery?
Roof leaking water or dangerous icicles hanging? Gutters clogged with ice?
Worried about power going out and need a whole home generator installed for your family?
Concerned with possible power surges and brown outs and you want to protect your electronics, tv's computers, refrigerator, air-conditioning and would like whole home surge protection?
Call 973-728-5745 and schedule a site visit today.
Q. Why do I need a on site evaluation?
A. We need to measure, check the utilities (gas or electrical), type of ground work required such as pavers, asphalt, concrete, tar and chip, we need to evaluate the drainage, and the condition of the existing ground.
Q. How do I get started - How do I schedule a site evaluation?
A. We have a short single page form with some basic questions. The average time to complete is less than 5 minutes.
Q. Once I fill out the form, then what?
A. We will review the information and start a file. We will email you to advise that your file is started, we will also arrange with you a date for the site visit.
Q Do i need to be home for the site visit?
A. Generally No, Our primary site evaluation is done to provide you a quote range for your project. Once you receive the quote, you review and decide if you would like a system installed. Should you decide you would like to have a system installed we will arrange a date to meet on site with you to go over the proposed design, answer any additional questions and set a date to start.
Q. When is the best time to install a system?
A. As early in the season as possible. We run our preseason specials throughout the winter providing up to 15% off our normal on season rates.
Q. When is your preseason, when is your regular season? We quote systems all winter long. Clients sign up and we start to install generally in late April.
Generally speaking we are booked for the season by late spring, early summer as everyone interested wants it installed for the upcoming winter Ice and Snow season.
If you can provide the following information we will be glad to provide you a quote by email.
1- Exact size of the Driveway, Walkways or Roofing area.
2-The size of the area to be heated.
3- The amount of asphalt, cement to be removed (in tons).
4- The amount of ground work to be removed (in tons).
5- The amount of gravel, QP, sand, insulation required (in tons).
6- The compacted thickness of the asphalt or the thickness of the concrete pour.
7- The capacity of your gas line or electrical service (in BTUH or KW).
8- Incline of the area to be resurfaced. (if variable we will require plans showing the grading) .
9- A line drawing of the installation site, showing all points of interest.
10- Distance from the installation site of the nearest construction debris recycle center that will accept asphalt, cement and other hardscape materials and the cost per ton.
If all the above factors are known we can provide you an accurate quote by email.
Open today | 09:00 am – 05:00 pm |
Copyright © 2024 Heatingdriveways.com - All Rights Reserved.
Powered by GoDaddy Website Builder